EASYCOAT 30 Setting Type Gypsum Powder features

• High quality finish No more crack and sandy surface since it provides a smooth ivory finish that can be trowel-led to a matt or polished finish or even painting if required.
• Time saving No need to cure like concrete. Just after dried out, you can proceed the next step.
• Easy to mix Provides good mixing qualities with minimal effort. Just tear a package and mix with clean water. It’s then ready to use.
• Easy to apply Easy application qualities for the installer. Use less effort to apply due to the very soft compound body.
• Only one product needed For gypsum board, can be used for treating both joints and gypsum board surface.

EASYCOAT 30 Setting Type Gypsum Powder application

• Mixing
  • Pour EASYCOAT 30 Setting-Type Gypsum Powder into clean water with mixture ratio 1:2 and mix it with a drill or plunger until you have a creamy consistency
• Jointing
  • Treat all joints using EASYCOAT 30 Setting-Type Gypsum Powder with appropriate joint tape
• Lay on
  • Lay on the first coat a thickness of 2 mm. If need 5 mm thickness, lay on the second coat once the first one becomes damp
• Flatten Down
  • You can flatten down when the plaster starts to pick up (firms on surface). You should flatten down with a dry or slightly wet trowel to achieve a flat appearance
• First Trowel
  • Repeat stage 4 but this time use a slightly wet towel. You might find that at this stage an acceptable matt finish is achieved if a high quality finish is not required
• Second Trowel
  • By repeating stage 5 a high quality matt or polished finish can be achieved by Thoroughly clean all tools and equipment after use